is designed to be used when the waste pipeline is blocked with something hard and brittle.
The tool is attached to the end of the rods and inserted into the pipeline. The rods are then pushed until the blockage is reached. At this point a pumping action is used to break up the blockage.
Our Flexicoil Spearhead is only available in one size.
is designed to allow you to rotate your rods inside the waste pipe.
To use, attach it the end of the rods. Grip the front of the handle in one hand and rotate with the other.
are manufactured with a taper locking system to ensure the rods stay together in the pipe.
The only way to unlock the rods is to use the Hook Spanner which is especially manufactured to unwind the rods.
was designed to assist in the turning of the rods in the waste pipe, by allowing you to attach it to a drill.
To use, attach the Drill Adaptor at the turning end of your rods, and slot the hard bit into your drill. Turn your drill slowly and carefully to begin, to not damage your pipes.
Our Drill Adaptor is only available in one size.
is designed to be used when you have a soft fatty build-up constricting the diameter of the waste pipeline.
To clean fatty build up, attach the Flexicoil Brush to the end of the rods and insert into the pipeline. Sweep the pipeline whilst rotating the brush for a better cleaning action.
Our Flexicoil Brush is only available in one size.
is designed to be used to clear blockages in the waste pipes found under your basins, sinks, toilets, baths and showers.
The coiled spring gives you the flexibility needed to go round sharp bends.
Flexicoil Snake Spring Rods are joined by screwing the rods in a clockwise direction. The Snake Rods are manufactured with a taper locking system to ensure the rods stay together in the pipe. The only way to unlock the rods is to use the Hook Spanner which is specially manufactured to unwind the rods.
Once in use, the rods should only be rotated in a clockwise direction.
Our Flexicoil Snake Spring Rods are only available in 1m lengths
is the ideal tool for cleaning blockages stuck in the bends of your waste pipes.
Put the Bulb Auger on the end of the rods. Insert the rods into the pipes and rotate. This rotating action will aid in moving the rods around the bends in the pipes. When the blockage is encountered, continue to turn the rods until the blockage is cleared and pushed out of the waste pipe, into the outside pipe.
Our Bulb Auger is only available in one size.